DeskTop Display System B190 Flippa Desk Conversion Base Black

10102685 B190 Arnos Flippa Display System B190 Desk Conversion Base Black - each A4 Black 200x260x20mm The Standard Conversion Base is available in different sizes for the A4 & A5 systems and is designed for the best ergonomic viewing positions when sitting. It will hold all available Flippa panels. Available in black (to hold 10 panel mounting brackets) or white (to hold 6 panel mounting brackets). All products pictured above have Standard Conversion Bases. for instructions on Assembly. FLIPPA Desk Conversion Base (B190) Assembly Instructions Stand Support Bracket vertically on Base . Place screw (1/2 x 1/4 inch BSW) in rear hole on Base . Attach washer and nut from underside of Base. Repeat steps 2 and 3 with second screw and nut. For 10 Panel capacity, place one Mounting Bracket in line with centre hole of Support Bracket . Insert screw (1/2 X 1/4 BSW) from front and attach washer and nut from rear. Insert screws (2 x 1/2 X 1/4 BSW) in bottom of Mounting Bracket and attach washers and nuts from underside Base . Tighten all nuts. Remove bumpons from strip. Place bumpons on 4 corners of underside of Base, pressing firmly to stick in place. NOTE: Support Bracket must always be fitted for stability of unit. For 20 Panel capacity, two only Mounting Brackets are required. Each to line up with outside two holes on Support Bracket and corresponding outer holes on Base.